Control Box; Pr-1 Radio Transmitter - PowerTech PW330L User Manual

1.3.1 PW320/PW330/PW330L Electromechanical Gear Motors
PW320/PW330/PW330L consists of a worm screw
reduction gear and a 24V direct current motor. The gear
motor could be released manually by special release
keys when there is a power failure.
The gear motor is installed with two post brackets, one
rear plate and one front plate for the installation.
Table 1: List of small parts
Front plate
Rear plate
Post bracket
M8*25L hex bolt
M8 self-locking nut
M12 *25L hex bolt
M12 self-locking nut
Release key

1.3.2 Control Box

Control box consists of one control panel with
incorporated receiver, one transformer and two back-up
batteries.
Provides the complete automation of the gear motors
and other accessories of PW320/PW330/PW330L kit.
To connect separate terminals on the control panel and
activate the gear motors and other accessories, the
installation manual has to be carefully read beforehand.
Table 2: List of small parts for Control Box
5*30 Screw
Nylon screw anchor
1.3.3 PH-2 Photocells
The pair of PH-2 photocells has to be installed on the
wall and connected to the control panel. The function of
the photocells is to detect the obstacles found on the
optical axis between the transmitter (TX) and the
receiver (RX).

1.3.4 PR-1 Radio Transmitter

PR-1 radio transmitter is used for the remote control of
the gate movement. To use the transmitter, press and
hold the button for 1 second. There are two buttons on
the transmitter and (A) button is "open-stop-close
mode" and (B) button is "pedestrian mode".
4
INSTRUCTIONS PW320/PW330/PW330L
PW320 PW330/PW330L
2pcs 2pcs
4pcs 2pcs
4pcs 4pcs
4pcs 4pcs
2pcs 4pcs
0 2pcs
2pcs 2pcs
2pcs 2pcs
Quantity
4 pcs
4 pcs
Figure 3
1)PW320
2)PW330/PW330L
3)Release Key
Figure 4
Figure 5
TX
Figure 6
RX