Compaq Armada V300 Series Reference Manual page 181

All Compaq systems equipped with laser products comply with
appropriate safety standards, including IEC 825. With specific
regard to the laser, the equipment complies with laser product
performance standards set by government agencies for Class 1
laser products. It does not emit hazardous light; the beam is totally
enclosed during all modes of customer operation and maintenance.
The Center for Devices and Radiological Health (CDRH) of the
U.S. Food and Drug Administration implemented regulations for
laser products on August 2, 1976. These regulations apply to laser
products manufactured from August 1, 1976. Compliance is
mandatory for products marketed in the United States.
!
Laser Type:
Wave Length:
Divergence Angle:
Output Power:
Polarization:
Numerical Aperture:
Only authorized technicians trained by Compaq should attempt to
repair this equipment. All troubleshooting and repair procedures
are detailed to allow only subassembly/module level repair.
Because of the complexity of the individual boards and sub-
assemblies, no one should attempt to make repairs at the
component level or to make modifications to any printed wiring
board. Improper repairs can create a safety hazard.
This system is classified as a
Class 1 laser product. This
label appears on the laser
product.
Semiconductor GaAlAs
780 r 35 nm
53.5 degrees r 1.5 degrees
Less than 0.2mW or 10,869 W·m
Circular
0.45 r 0.04
-2 -1
sr