Table of Contents
Advertisement
PZS-3
10. Programming the PZS-3
Programming the length of the phases is done the same way for the
five different stops (two terminus stations, two stops, all extra halts).
Carry out the programming steps 1 to 3 for all stops you want to
program.
Programming step 1: Choosing a stop
Intermittently earth the programming input "select" (17) to point (4).
The LED on the module flashes and thus indicates the 1
to be programmed. By connecting the programming input once again to
earth you switch to the programming of the next stop. The number of
flashlights between the pauses indicates the one of the five stops
ready to be programmed.
If you do not want to program a stop you can skip this halt by
connecting the programming input once again to earth.
If you connect the programming input once again to earth after having
reached the programming of the 5
returns to standard operation.
Stop
Number of flashlights
1
1
2
2
3
3
4
4
5
5
th
stop the module automatically
Stop ready to be programmed
Terminus station 1
Stop 1
Terminus station 2 (both rails)
Stop 2
Extra halt(s)
English
st
stop is ready
Page 33
Advertisement
Table of Contents
