Maintenance And Servicing; Replacing Carbon Brushes - Chicago Electric 97580 Set Up And Operating Instructions Manual

mAintenAnce And
seRVicing
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
FRom AccidentAl
opeRAtion:
turn the power switch of the
tool to its "oFF" position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
to pReVent seRious
injuRY FRom tool
FAiluRe:
do not use damaged
equipment. if abnormal noise
or vibration occurs, have the
problem corrected before
further use.
cleaning, maintenance, and
lubrication
1. BeFoRe eAcH use,
general condition of the tool. Check
for loose screws, misalignment or
binding of moving parts, cracked or
broken parts, damaged electrical
wiring, and any other condition that
may affect its safe operation.
AFteR use,
2.
of the tool with clean cloth.
3. Check the condition of Blades. Bent,
cracked, worn or dull blades will
not operate properly and can cause
SKU 97580
to pReVent
seRious injuRY
inspect the
clean external surfaces
For technical questions, please call 1-800-444-3353.
damage or injury. Discard damaged
or worn blades.
4. wARning! if the supply cord of
this power tool is damaged, it must
be replaced only by a qualified
service technician.

Replacing carbon Brushes

1. To inspect or replace the Carbon
Brushes, remove the Brush Caps
(54) located on the top and underside
of the Main Housing (53).
2. With the Caps removed, the Brush
Holders (55) and Carbon Brushes
(56) may fall out.
3. Inspect the Carbon Brushes. They
should not be chipped or cracked,
and the carbon portion must be at
least 1/4 in length.
One of the Carbon Brush Caps (54)
4. If the Carbon Brushes are worn or
damaged, they must be replaced.
Replacement Carbon Brushes are
available from Harbor Freight Tools.
Page 12