Cal Spas Swim-Pro F-1641 Owner's Manual page 40

38
Setting Preferences
Press
Then
Press
Utilities
This menu feature is for system information only and is used mainly for repair and troubleshooting.
Other Spa Systems
Several spa functions operate in the background and require no action or maintenance from you. This is for
your information only.
Pumps
Press the "Jets 1" button once to turn pump 1 on or off, and to shift between low- and high-speeds if equipped.
If left running, the pump will turn off after a time-out period. The pump 1 low-speed will time out after 30
minutes. The high-speed will time out after 15 minutes.
On non-circ systems, the low-speed of pump 1 runs when the blower or any other pump is on. If the spa is in
Ready Mode, Pump 1 low may also activate for at least 1 minute every 30 minutes to detect the spa temperature
(polling) and then to heat to the set temperature if needed. When the low-speed turns on automatically, it
cannot be deactivated from the panel, however the high speed may be started.
Circulation Pump
The circulation pump will come on when the system is checking temperature (polling), during filter cycles,
during freeze conditions, or when another pump is on.
The ozonator will run with the circulation pump during filtration cycles.
Purge Cycles
In order to maintain sanitary conditions, secondary Pumps and/or a Blower will purge water from their respective
plumbing by running briefly at the beginning of each filter cycle.
www.calspas.com
This allows you to set the following preferences for system operation:
Once
• Change the temperature between Fahrenheit and Celsius
• Change the clock between 12-hour and 24-hour display
9X
• Turn periodic reminders (like "CLEAN FILTER") on or off
Toggle 12-hour clock
and 24-hour clock
Toggle °F and °C
Toggle Yes and No
to set
to set
to set
2018 Fitness Spa
LTR20181146, Rev. M