Hach DR/2010 Instrument Manual page 64

8. Press so the decimal point flashes. Set the decimal point
ENTER
position using the arrow keys. Press
flash again. Press the
9. The display gives the next prompt:
 &&&&
10. To change the units, press
keys to select one of the available units of measure. The menu
ARROW
includes:
mg/L, µg/L, ng/L, ppm, ppb, ppt, g/kg, mg/kg, oz/gal, lb/ac,
kg/ha,%, g/gal, mg/100g, mg%, units, ftu, mol/L, mmol/L,
Note: The first display in the units menu is blank (NONE). If the desired unit is
not included above, selection of the blank reserves all sixteen character spaces
for input at the next (SYMBOL) prompt; a custom unit can then be constructed
along with the symbol describing the method.
11. When the appropriate units selection appears, press
12. Press the
DOWN ARROW
The display then prompts:
 &&&&
13. Press . The display will show the selected units followed by a
ENTER
flashing cursor. In the remaining spaces after the semicolon, add
various characters to construct a chemical symbol or otherwise
describe the method.
There are two techniques for constructing the symbol:
a) Selecting characters by entering appropriate numeric codes with
the keypad (see "Constructing a Display Using Numeric Codes"
on page 65). Press
b) Scrolling through the character menu with the
(see "Constructing a Display By Scrolling" on page 67). Press
twice to capitalize letters, subscript or superscript numbers.
SHIFT
Press after the desired character is displayed. Press
ENTER
again to accept the character string. Continue to Step 14 on
page 68.
ENTER
key to go to the next selection.
DOWN ARROW
# &&&
7 EJI 
so that (None) is flashing. Use the
ENTER
to go to the next selection.
# &&&
5 >
after each character is selected.
ENTER
64
The Decimal prompt will
.
nm
A
and
meq/L.
.
ENTER
nm

keys
ARROW
ENTER