Cancelling Delayed Transmissions (Queued); Immediate Transmission; Fax Direct Transmission; Cancelling Direct Transmission - Kyocera Triumph-Adler P-4025w Operation Manual

Sending Faxes > FAX Direct Transmission

Cancelling Delayed Transmissions (Queued)

1
2

Immediate transmission

1
2

FAX Direct Transmission

The destination is dialed and communication starts before the original is scanned, allowing you to verify that each page
of the fax has been properly sent.
Setting for Direct transmission
On
Off
NOTE
In direct transmission, you can designate only one destination for one transmission.

Cancelling Direct Transmission

During direct transmission, to cancel communication during transmission, select the [Stop] key on the operation panel.
The originals that have been scanned are ejected, and the screen returns to the send default screen. When originals
remain in the document processor, take them out.
NOTE
In some cases, transmission may take place even if the [Stop] key is selected.
Display the screen.
[Status/Job Cancel] key > [▲] [▼] key > [Scheduled Job] > [OK] key
Display the scheduled job screen.
Canceling a job.
Select the job you want to cancel and select [Cancel] > [Yes].
The selected job is deleted.
Display the screen.
[Status/Job Cancel] key > [▲] [▼] key > [Scheduled Job] > [OK] key
Display the scheduled job screen.

Immediate transmission.

Select the job you want to send by immediate transmission, select [Menu] > [▲] [▼] key >
[Start Now] > [OK] key > [Yes].
The transmission will start.
Starts direct transmission.
Dials the receiving system, and after the communication has started, originals are
scanned.
Starts memory transmission.
After originals are scanned into memory, the communication starts.
Description
3-20