Cleaning; Cleaning The Machine - Toro 68013 Operator's Manual

5. Loosen the carriage bolts and nuts that secure
the wipers to the paddle bladess
Note:
If necessary, tip the drum to the dump
position to access the paddles.
Figure 77
1. Wiper
2. 3 to 6 mm (1/8 to 1/4 inch)
3. Wiper bar
6. Adjust the rubber wipers to be close to the drum
wall and position the metal paddle blades so
that the outer edge is 3 to 6 mm (1/8 to 1/4 inch)
from the outer edge of the wipers
Tighten the nuts and bolts to secure the blades
to the paddles.
Note:
Ensure that the clutch lever is in the O
position and rotate the paddles as needed.
7. Install the grate with the nuts and bolts that you
removed in step 4, and tighten the nuts and
bolts until they are secure.
(Figure 77).
g029188
4. Paddle blade
5. Carriage bolt
(Figure 77).

Cleaning

Cleaning the Machine

Regular cleaning and washing with mild detergent and
water increases the life span of the machine. Clean
the machine after each use before the dirt hardens.
Remove dirt and grime from the external parts of the
entire machine, especially the engine. Clean dirt and
concrete materials from the outside of the engine.
Ensure that the fuel cap and the oil-fill cap/dipstick are
secure to avoid getting water in the engine.
Use care when using a high-pressure sprayer
because it can damage the safety decals, instruction
signs, and the engine.
Important:
Lubricate the bearings and seals after
cleaning; refer to
Seals (page 29).
FF
47
Lubricating the Bearings and