Table of Contents
Advertisement
10.
Align the O-ring in to the groove in the sediment
cup and install the sediment cup to the fuel-valve
housing.
11.
Move the lever of the fuel valve to the O
position (all the way to the right) and check for
leaks. If it leaks, replace the O-ring.
Draining the Fuel Tank
1.
Remove the engine; refer to
Engine (page
35).
2.
Remove the fuel cap by rotating it
counterclockwise
Figure 57
3.
Align a drain pan to the hinge of the engine deck.
4.
Rotate the engine on the hinge side of the
engine deck and drain the fuel from the tank
(Figure
58).
Figure 58
5.
Carefully lower the engine and engine deck.
6.
Install the fuel cap.
7.
Install the engine; refer to
(page
36).
Removing the
(Figure
57).
Installing the Engine
Drive System
Maintenance
N
Tire Air Pressure
The following table shows the appropriate air pressure
for the tires as installed at the factory.
Important:
the actual tires for the correct air pressure
requirement.
Model
68013, 68014, 68016, and
68017
68020, 68021, and 68024
Inspecting the Tires
Service Interval: Before each use or daily
WARNING
Failure to maintain correct tire pressure
g035167
may result in tire failure and loss of control,
resulting in property damage and serious
injury or death.
• Check the tire pressure frequently to
ensure proper inflation. If the tires are not
inflated to the correct pressure, they will
wear prematurely.
• Inspect the tire condition before towing
and after any operating accident.
The DOT tire information is located on the side of
each tire. This information gives load and speed
ratings. Replacement tires should have the same or
better ratings
Note:
Ensure that any tires installed on your machine
meet or exceed the weight requirements of your
machine as listed in
g035168
1.
Visually inspect the tires for damage and wear
(Figure 59
37
Always check the information on
Maximum Air Pressure
414 kPa (60 psi)
241 kPa (35 psi)
Specifications (page
and
Figure
60).
16).
Advertisement
Table of Contents
