Toro 68013 Operator's Manual page 39

6. Align a rag below the oil-level port in the side
of the reduction case.
7. Remove the oil-level-check bolt and washer
from the oil-level port
•
If the oil level is below the threads in the
oil-level port, add oil as follows:
A. Remove the filler bolt and washer from
the filler port on the top of the reduction
case (Figure
B. Slowly pour the specified oil into the fill
port until the oil level is level with the
threads at the bottom of the oil-level
port.
C. Install the filler bolt and the washer to
the filler port of the reduction case, and
tighten the filler bolt
•
If the oil level is too high, allow the oil to flow
out until it is flush with the threads at the
bottom of the oil-level port.
8. When the oil is level is flush with the threads
at the bottom of the oil-level port, install the
oil-level-check bolt and washer to the port, and
tighten the bolt (Figure
9. Install the divider plate; refer to
Divider Plate (page
Changing the Reduction-Case Oil
Service Interval: After the first 20 hours—Change the
reduction-case oil (Models 68013
and 68014 only).
Every 100 hours/Every 6 months (whichever
comes first)—Change the reduction-case oil
(Models 68013 and 68014 only).
1. Park the machine on a level surface and shut
off the engine.
2. Allow the engine to cool.
3. Disconnect the wire from the spark plug; refer to
Disconnecting the Spark-Plug Wire (page
4. Remove the engine; refer to
Engine (page 35).
5. Drain the fuel tank; refer to
Tank (page 37).
6. Remove the filler bolt and washer from the filler
port on the top of the reduction case
(Figure 62).
62).
(Figure 62).
62).
Installing the
28).
Removing the
Draining the Fuel
(Figure
1. Oil-level-check
bolt
2. Washer
7. Remove the oil-level-check bolt and washer
from the oil-level port in the side of the reduction
case (Figure
8. Align a drain pan to the hinge of the engine deck
(Figure
28).
9. Rotate the engine on the hinge side of the
engine deck, and drain the oil from the reduction
case (Figure
10. Carefully lower the engine and engine deck.
11. Slowly pour the specified oil into the fill port
63).
until the oil level is level with the threads at the
bottom of the oil-level port
12. Install the oil-level-check bolt and washer to the
oil-level port of the reduction case, and tighten
the bolt
39
Figure 63
3. Oil-level port
4. Pulley
63).
64).
Figure 64
64).
(Figure
(Figure 63).
g020127
5. Filler port
6. Filler bolt
g020128
62).