Toro 68013 Operator's Manual page 41

1. Fill plug
2. Sight glass
6. If the oil level is below the bottom 1/3 of the sight
glass, add oil as follows:
A. Remove the fill plug from the fill port in the
housing of the gearbox
B. Slowly pour the specified oil into the fill port
until the oil level is between 1/3 and 1/2 of
the sight glass
C. Clean the fill plug.
D. Apply PTFE thread-sealing tape to the
threads of the plug.
E. Install the plug into the fill port in the housing
(Figure 66).
Replacing the Gearbox Oil
Service Interval: Every 800 hours (gearbox models
only).
1. Park the machine on a level surface and shut
off the engine.
2. Allow the engine to cool.
3. Disconnect the wire from the spark plug; refer to
Disconnecting the Spark-Plug Wire (page
4. Align a drain pan with a 2.8 L (3 US qt) capacity
under the drain plug
5. Remove the drain plug from the drain port and
completely drain the gearbox oil
6. Remove the fill plug
Figure 66
3. Drain plug
(Figure 66).
(Figure 66).
(Figure 66).
(Figure
(Figure 66).
7. Clean the drain and fill plugs and apply PTFE
thread-sealing tape to the plug threads.
8. Install the drain plug in the drain port
9. Slowly pour the specified oil into the fill port until
the oil level is between 1/3 and 1/2 of the sight
glass
10. Install the fill plug in the fill port
g019900
28).
66).
41
(Figure 66).
(Figure 66).
(Figure 66).