Mixing The Material - Toro 68013 Operator's Manual

Mixing the Material

DANGER
Eye and skin contact with concrete materials
and breathing the dust involved is hazardous
to your health.
• Ensure that there is adequate air
ventilation.
• Wear a dust mask to prevent inhalation of
dust while using the machine; refer to
Operating Practices (page
• Avoid direct contact of cement and
concrete materials with skin and eyes.
DANGER
This machine is capable of amputating hands.
• Stay in the operator's position while the
machine is running.
• Keep all bystanders a safe distance away
from the machine.
• Stop the machine immediately if any
people or animals enter the work area.
• Never place any part of your body into a
position that causes an unsafe operating
condition.
Important:
Do not add more material than
the batch capacity of the machine; refer to
Specifications (page
Note:
Follow the manufacturer's instructions that are
printed on the packaging of the product you are using.
1. Ensure that there is no old, loose material in
the drum that can contaminate the batch of
material; refer to
and Dumping the Material (page
the drum to the upright position.
Note:
Ensure that the drum is in the mix
position (upright) and the drum latch is engaged.
2. Move the clutch lever to the O
35 or Figure 36).
3. Start the engine.
Note:
Allow the engine to warm up at 2/3
throttle for 1 to 2 minutes.
4. Set the throttle lever on the engine to the M
position.
5. Move the clutch lever to the O
35 or Figure 36).
4).
16).
Cleaning the Drum (page 26)
26), then return
position
FF
position
N
Safe
1. O position
FF
1. O position
N
6. Add the ingredients for the batch as follows:
A. Pour water into the drum through the grate.
(Figure B. Add the plaster, cement, or other binding
material.
Note:
plaster, and binding materials by lowering
the bag onto the bag splitter
AX
(Figure
25
Figure 35
Belt-Drive Models
2. O position
N
Figure 36
Gearbox Models
2. O position
FF
You can open bags of cement,
(Figure
g019873
g019872
37).