Servicing The Gearbox - Toro 68013 Operator's Manual

13. Install the filler bolt and washer to the filler port
of the reduction case and tighten the filler bolt
(Figure 63).
14. Install the engine; refer to
(page 36).

Servicing the Gearbox

Gearbox Models Only
Checking the Clutch Operation
Service Interval: Before each use or daily (gearbox
model only).
After the first 25 hours (gearbox model only).
Important:
Check the gearbox clutch if the
paddles rotate when the clutch lever is in the O
position, if the paddles rotate slowly, or if the
clutch begins to slip.
1. Move the clutch lever to the O
2. Start the engine.
3. Ensure that the engine throttle is set to the 2/3
position.
4. If the paddles rotate with the clutch lever to the
O position do the following:
FF
A. Shut off the engine.
B. Locate the clutch lever at the back of the
machine; refer to
C. Move the clutch lever to the O
D. Attach a spring scale with a range of 15 to
30 kg (35 to 55 lb) to the grip of the clutch
lever (Figure
1. Spring scale
2. 15 to 30 kg (35 to 55 lb)
E. Using the spring scale, pull the clutch
handle to the O
Figure 65.
Installing the Engine
position.
FF
Clutch Lever (page
position.
FF
65).
Figure 65
3. Clutch lever
position as shown in
N
F. Observe the spring scale while pulling to
see what the highest pressure is when
moving the clutch handle from the O
position to the O
Note:
kg (35 to 55 lb).
G. If the clutch pressure is greater than or
less than 15 to 30 kg (35 to 55 lb), contact
an Authorized Toro Service Dealer.
Gearbox-Oil Specifications
Oil type: SAE 90 gear oil
Gearbox capacity: 2.13 L (72 fl oz)
Checking the Gearbox Oil
FF
Service Interval: Every 40 hours (gearbox model
Important:
low or too high and you run the engine, you may
damage the engine or the gearbox. This type of
damage is not covered by the warranty.
1. Park the machine on a level surface and shut
off the engine.
2. Allow the engine to cool.
3. Disconnect the wire from the spark plug; refer to
Disconnecting the Spark-Plug Wire (page
14).
4. Locate the gearbox between the engine and the
front cowl.
5. At the right side of the gearbox, examine the oil
level in the sight glass
g022166
40
position
N
Normal clutch pressure is 15 to 30
only).
If the oil level in the gearbox is too
(Figure
FF
(Figure 65).
28).
66).