Ics Control; Alarm Setting; Figure 5-15 Gain Control Setting; Figure 5-16 Ics Control Setting - ADRF SDR-ICS-43-6 User Manual

Table of Contents



Downlink Gain/Uplink Gain: Allows the UL gain to be adjusted manually when ALC is OFF



DL Output ALC Level: Prevents the output power from exceeding the specified value



DL Output ALC Offset: When the incoming signal level increases, the system will not adjust the attenuation

levels until the delta reaches the level specified



DL /UL Gain Balance ON: Allows the user to enable or disable the gain balance. When gain balance is

enabled, the delta value between the downlink and uplink gains remain constant

5.3.5 ICS Control



DL ILC Level: Allows the user to specify the interference level control. The measured isolation value + ILC

Level will provide you with the MAX gain level. When the ILC Level + User Set Gain Level is larger than the

measured isolation value, ILC will adjust the gains levels to match the measure isolation value.



Downlink Signal Low: Allows the user to specify how low the signal can be before triggering a "Downlink

Signal Low" soft-fail alarm



Downlink Signal Not Detected: Allows the user to specify how low the signal can be before triggering a

"Downlink Signal Not Detected" soft-fail alarm



Downlink RF Power: Allows the user to set a maximum deviation value for the downlink RF power

For example, if the input signal is -50 dBm and the gain is set to 60 dB, the expected output power should

be 10 dBm. If the Downlink RF Power alarm value is set to 6dB, then if the output power is below 4 dBm,

then this will trigger a soft-fail alarm

Advanced RF Technologies, Inc.

Table of Contents