Lexmark CX522 User Manual page 93

Understanding the printer menus
Menu item
Toner patch sensor setup
Print TPS information page
App Configuration
LES Applications
Off
On*
Scanner Configuration
Scanner Manual Registration
Print Quick Test
Scanner Configuration
Scanner Manual Registration
Front ADF Registration
Rear ADF Registration
Flatbed Registration
Scanner Configuration
Edge Erase
Flatbed Edge Erase
0–6 (3*)
ADF Edge Erase
0–6 (3*)
Scanner Configuration
ADF Deskew
ADF Mechanical Deskew
Off
On
Auto*
Scanner Configuration
Disabled Scanner
Enabled*
Disabled
ADF Disabled
Scanner Configuration
Tiff Byte Order
CPU Endianness*
Little Endian
Big Endian
Note: An asterisk (*) next to a value indicates the factory default setting.
Description
Print a diagnostic page that contains information on toner patch
sensor calibration.
Enable the Lexmark Embedded Solutions (LES) applications.
Notes:
•
This menu item is available only in some printer models.
•
When set to On, this setting does not affect built‑in
applications.
Print a Quick Test target page.
Note: Make sure that the margin spacing on the target page
is uniform all the way around the target. If it is not, then the
printer margins may need to be reset.
Manually register the flatbed and ADF after replacing the ADF,
scanner glass, or controller board.
Set the size, in millimeters, of the no‑print area around an ADF
or flatbed scan job.
Set the printer to perform ADF mechanical skew adjustment.
Disable the scanner when it is not working properly.
Set the byte order of a TIFF‑formatted scan output.
93