Digital Output Magnetometers: Supported Commands; Table 10. Digital Output Magnetometers: Supported Commands List - ST STM32F103RET6 User Manual

4.2.6

Digital output magnetometers: supported commands

Table 10. Digital output magnetometers: supported commands list

devices/demonstration boards including a digital output magnetometer.
Command
*setdbXXXVY
*start
*debug
*stop
*Zon
*Zoff
*dev
*ver
*mrAA
*mwAADD
*single
*list
*listdev
*echoon
*echooff
(1)
*mfiforst
(1)
*mfifomde
(1)
*mfifostr
(1)
*mfifostf
(1)
*mfifobtf
(1)
*mfifobts
(1)
*mfifodstr
1. Available only for devices with embedded FIFO.
UM0979 - Rev 6
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Table 10. Digital output magnetometers: supported commands list
Description
Selects firmware according to the adapter connected
Starts continuous data acquisition
Returns the output data in readable text format
Stops data acquisition
Forces 3-state
Exits from 3-state
Device name
Firmware version
Magnetometer register read
Magnetometer register write
It gets a single X, Y, and Z data acquisition
Prints the list of MKIs supported
Prints the list of devices supported
Activates the write verbose mode
Deactivates the write verbose mode
Magnetometer "Reset mode" enable
Magnetometer "FIFO mode" enable
Magnetometer "FIFO Stream" enable
Magnetometer "Stream-to-FIFO" enable
Magnetometer "Bypass-to-FIFO" enable
Magnetometer "Bypass-to-Stream" enable
Magnetometer "Dynamic Stream" enable
below lists the commands supported by the
Returned value
(see Table 4. Returned values for *start
(see Table 5. Returned values for *debug
e.g.: LIS3DH
e.g.: V1.0
e.g.: MRAAhDDh
(see Table 5. Returned values for *debug
e.g.: MKI105V1
e.g.: LIS3DH
e.g.: MRAAhDDh
st 0 0 0 0 0 0 IR FC FS
st 0 0 0 0 0 0 IR FC FS
st 0 0 0 0 0 0 IR FC FS
st 0 0 0 0 0 0 IR FC FS
st 0 0 0 0 0 0 IR FC FS
st 0 0 0 0 0 0 IR FC FS
st 0 0 0 0 0 0 IR FC FS
UM0979
Supported commands
command)
command)
command)
page 27/39