Digital Output Accelerometers: Supported Commands; Table 6. Digital Output Accelerometers: Supported Commands List - ST STM32F103RET6 User Manual

4.2.2

Digital output accelerometers: supported commands

Table 6. Digital output accelerometers: supported commands list

devices/demonstration boards including a digital output accelerometer.
Command
*setdbXXXVY
*start
*debug
*stop
*Zon
*Zoff
*dev
*ver
*rAA
*wAADD
*single
*list
*listdev
*echoon
*echooff
(1)
*fiforst
(1)
*fifomde
(1)
*fifostr
(1)
*fifostf
(1)
*fifobtf
(1)
*fifobts
(1)
*fifodstr
1. Available only for devices with embedded FIFO.
Note: IR: interrupt byte; FC: FIFO control register; FS: FIFO source register.
UM0979 - Rev 6
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Table 6. Digital output accelerometers: supported commands list
Description
Selects firmware according to the adapter connected
Starts continuous data acquisition
Returns the output data in readable text format
Stops data acquisition
Forces 3-state
Exits from 3-state
Device name
Firmware version
Accelerometer register read
Accelerometer register write
It gets a single X, Y, and Z data acquisition
Prints the list of MKIs supported
Prints the list of devices supported
Activates the write verbose mode
Deactivates the write verbose mode
Accelerometer "Reset mode" enable
Accelerometer "FIFO mode" enable
Accelerometer "FIFO Stream" enable
Accelerometer "Stream-to-FIFO" enable
Accelerometer "Bypass-to-FIFO" enable
Accelerometer "Bypass-to-Stream" enable
Accelerometer "Dynamic Stream" enable
below lists the commands supported by the
Returned value
(see Table 4. Returned values for *start
(see Table 5. Returned values for *debug
e.g.: LIS3DH
e.g.: V1.0
e.g.: RAAhDDh
(see Table 5. Returned values for *debug
e.g.: MKI105V1
e.g.: LIS3DH
e.g.: RAAhDDh
st 0 0 0 0 0 0 IR FC FS
st 0 0 0 0 0 0 IR FC FS
st 0 0 0 0 0 0 IR FC FS
st 0 0 0 0 0 0 IR FC FS
st 0 0 0 0 0 0 IR FC FS
st 0 0 0 0 0 0 IR FC FS
st 0 0 0 0 0 0 IR FC FS
UM0979
Supported commands
command)
command)
command)
page 23/39