Section 11: Packing For Shipment; General Instructions; Packing Handheld Capnograph In Original Carton; Packing In A Different Carton - Mallinckrodt Nellcor NPB-70 Service Manual

Handheld capnograph

Hide thumbs

Table Of Contents

Table of Contents

SECTION 11: PACKING FOR SHIPMENT

11.1

GENERAL INSTRUCTIONS

11.2

PACKING HANDHELD CAPNOGRAPH IN ORIGINAL CARTON

11.1

PACKING IN A DIFFERENT CARTON

11.1 General Instructions

11.2 Packing Handheld Capnograph in Original Carton

11.3 Packing in a Different Carton

To ship a monitor or one of its components for any reason, follow the

instructions in this section. Failure to follow the instructions in this

section may result in loss or damage not covered by any applicable

manufacturer warranty.

Pack the monitor or component(s) carefully. If available, use the original

carton and packing materials and follow the instructions in "Packing

monitor in Original Carton." If the original shipping carton and material

are not available, use other suitable shipping materials and container and

follow the instructions in "Packing in a Different Carton."

Prior to shipping the monitor or a component, contact your local

representative for a Returned Material Authorization (RMA) number.

Mark the shipping carton and any shipping forms with the RMA and the

monitor's serial number.

Caution: Observe ESD (electrostatic discharge) precautions when

packing any monitor components.

If the original carton and packing material are available, repack the

monitor as follows. (Refer to Figure 11-1.)

Place the unit in a plastic bag. Place it into the corresponding

space, in the original foam padding, with the front panel facing up.

Place the foam padding cover over the top of the unit.

Seal the carton with packing tape.

Label the carton with the correct shipping address, return address

and RMA number.

If the original carton and packing material are not available or if shipping

any monitor component not in its original carton:

Place the monitor in a plastic bag or component in a plastic anti-

static bag.

Locate a corrugated cardboard shipping carton (approximately the

size of the monitor or component) with at least 200 pounds per

square inch (psi) bursting strength.

Fill the bottom of the carton with at least 2 inches of packing

material.

11-1