Flow Calibration Process - Mallinckrodt Nellcor NPB-70 Service Manual

Section 6: Flow Calibration Check
6.3

FLOW CALIBRATION PROCESS

6-2
To perform the Flow Calibration Process, refer to Table 6-1.
Objective
To access Flow
Calibration screen
To select Flow Cal.
To start Calibration
Wait until either a Fail or Pass message is displayed
If FAIL is displayed
If PASS is displayed
Table 6-1: Flow Calibration
Action
Simultaneously
long press
and
short press
short press
short press
Replace Flow
System and/or
Pump
(refer to Section 5:
Troubleshooting)
and repeat above
procedure
Exit Service Mode
Response