Table of Contents
Advertisement
3.
On the receiver front panel, hold enter while pressing menu to enter the advanced menu.
4.
Press menu to advance to Preset bn gn. The IR window will flash.
5.
Align the transmitter IR window with the receiver to send the presets to the transmitter.
Important: All QLX-D and ULX-D components must use 2.0 firmware or greater for proper functionality.
Mute/Active Button
The button is configured to toggle between Mute and Active. The following options are available:
•
Toggle: Press button to mute microphone, press again to pass audio
•
Push-to-Talk: Hold button to pass audio
•
Push-to-Mute: Hold button to mute microphone
•
Disabled: Button functionality off
Change button behavior using Wireless Workbench or the receiver front panel.
Menu path: IR PRESETS > GOOSENECK / BOUNDARY > MUTE BUTTON BEHAVIOR
Note: When the mute/active button is set to Disabled, the transmitter will still send TPCI data if the button is pressed.
High-Pass Filter
Each transmitter contains a high-pass filter.
The high-pass filter:
•
attenuates frequencies below 150 Hz by 12 dB per octave
•
reduces low-frequency noise caused by table vibration or air handling systems
Adjust high-pass filter settings using Wireless Workbench or the receiver front panel.
Menu path: IR PRESETS > GOOSENECK / BOUNDARY > HIGH PASS
Transmitter RF Power
Reference the following table for setting RF Power:
RF Power Setting
1 mW
10 mW
System Range
33 m (100 ft.)
100 m (330 ft.)
Application
For increased channel reuse at close distances
Typical setups
Shure Incorporated
15/23
Advertisement
Table of Contents
