Dmx-Controlled Operation; Addressing - EuroLite LED TMH-W400 User Manual

DMX-controlled operation

You can control the projectors individually via your DMX controller. Every DMX channel has a different
occupation with different features. The individual channels and their features are listed under DMX protocol.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the device will respond to the controller.
If you set, for example, the address to channel 14, the device will use the channel 14 to 26 for control.
Please, be sure that you don't have any overlapping channels in order to control each device correctly and
independently from any other fixture on the DMX-chain. If several devices are addressed similarly, they will
work synchronically.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
data received at the DMX-input, a green dot lights up on the display. If there is no data received, the dot
flashes.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
28/32 00137074, Version 1.0