Sound Control; Blackout; Dmx-Controlled Operation; Dmx-Protocol - EuroLite LED DMX Flash 6000K & UV User Manual

Sound Control

In order to select Sound Control, set the dipswitch 9 to ON. Strobe effects are sound-controlled.

Blackout

In order to select Blackout, set the dipswitch 10 to ON.

DMX-CONTROLLED OPERATION:

You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
For DMX-controlled operation set DIP Switch 10 to ON. Use DIP Switches 1 to 9 to set the desired DMX
addresses.
Each LED DMX Flash 6000K oder LED DMX Flash 6000K occupies 2 channels. To ensure that the control
signals are properly directed to each projector, the projector requires addressing. This is to be adjusted for
every single projector by changing the DIP-switches as set out in the table below.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX data link. If two, three or more projectors are
addressed similarly, they will work similarly.
Occupation of the DIP-switches:
Controlling:
After having addressed all LED DMX Flash devices, you may now start operating these via your lighting
controller.

DMX-Protocol

Channel 1 – Dimmer (000 – 255)
Channel 2 – Strobe
DMX Value Characteristic:
0 Blackout
1 – 10 Sound control
11 – 20 Brightness
21 - 255 Speed
19/39 00032738.DOC, Version 1.0