Dmx-Controlled Operation; Addressing; Dmx-Protocol; 14 Dmx Channel Mode - EuroLite LED TMH-30 User Manual

DMX-controlled operation

You can control the projectors individually via your DMX-controller.
The device has three different DMX channel modes.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-30/LED TMH-60 will respond to the controller.
If you set, for example, the address to channel 15, the device will use the channel 15 to 28 for control.
Please, be sure that you don't have any overlapping channels in order to control each LED TMH-30/LED
TMH-60 correctly and independently from any other fixture on the DMX-chain.
If several LED TMH-30/LED TMH-60 are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
TMH-30/LED TMH-60 via your lighting controller.
Note:
The modes of DMX512 data are shown via the DMX indicator.
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the DMX indicator to the right of the display will be flashing. If there is no data received at the
DMX-input, the DMX indicator does not light up.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last device in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol

The device has three different DMX channel modes. The Control Board allows you to assign the DMX
channel mode.

14 DMX channel mode

Control-channel 1 - Horizontal movement (PAN)
Push slider up in order to move the head horizontally (PAN).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
Control-channel 2 - Vertical movement (TILT)
Push slider up in order to move the head vertically (TILT).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
29/35 00066872, Version 1.0