Operation; Menu Options; Dmx-Controlled Operation - EuroLite LED MSB-100 DMX RGB 3W User Manual

The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the spot to the mains, the EUROLITE LED MSB-100 DMX RGB 3W starts running.
The device has two operating modes. It can be operated via the Display Module or it can be run in DMX-
controlled mode via a DMX controller.

Menu Options

1. „d.001": Addressing the device; the desired values can be selected via the UP (increasing) or DOWN
(decreasing) buttons. Press the ENTER button to confirm the desired address.
2. „dip.p": Reverse Display; by pressing the UP button, the display shows „dip.a" and the images run
normally. Press the ENTER button to confirm the desired parameter.
3. „H00...": This function shows total Operation Time of the device; operation time is displayed after the
blinking H on the display. The first two positions after the H stand for ten thousand and thousand; the
next three positions after the H stand for hundred, ten and one. All five positions together show the total
operation time of the device in hours.
4. „rest": Reset; Press the ENTER button to confirm.
The desired parameter of the following options can be selected via the UP or DOWN buttons. Press the
ENTER button to confirm the desired parameter.
5. „F1_n": Sound Control Mode off
„F1_y": Sound Control Mode on
6. „F2_n": Auto Mode off
„F2_y": Auto Mode on
7. „F3_n": Master/Slave Mode off
„F3_y": Master/Slave Mode on

DMX-controlled operation

The display allows you to assign the DMX fixture address, which is defined as the first channel from which
the LED MSB-100 DMX RGB 3W will respond to the controller.
Controlling:
After having addressed the LED MSB-100 DMX RGB 3W, you may now start operating it via your lighting
controller.
The display lights up and shows "d.001".
If no DMX signal is received, then the bar rotates about 75° from the
starting point before coming to a stop.
If a DMX signal is received, then the bar remains at the starting
point.
19/22 00035733.DOC, Version 1.1