Control Board - EuroLite LED TMH-W400 User Manual

Control Board

The Control Board offers several features: you can easily set the starting address or run the pre-
programmed program.
Press OK 2 x until the display is lit. Browse through the mode menu by pressing the arrow buttons (up and
down). Press OK 2 x in order to select the desired menu. Browse through the main menu by pressing the
arrow buttons up and down. Press OK to enter the respective menu item of the main menu. You can change
the selection by pressing the arrow buttons (left and right). Press OK in order to confirm. You can leave
every mode by pressing the arrow buttons (left and right). The functions provided are described in the
following sections.
Default settings shaded.
Mode menu Main menu
Run Mode
DMX Address
Channel Mode
Sensitivity
Invert Pan
Set
Invert Tilt
Display
No DMX Signal
Dimmer mode
LoadDefault
Manu PAN ...
Ver
System Errors
Sys
Total Fixture Hours
Partial Fixture Hours
Advan
180°
EN
Setting
Run Mode
DMX mode
This mode allows the unit to be controlled via any standard DMX controller.
Sound
With this function, you can run the internal program sound-controlled.
Auto mode (Auto 1 + 2)
With this function, you can run 2 different internal programs.
DMX Address
With this function, you can set the desired DMX address via the Control Board.
DMX channels
With this function, you can display the number of the DMX channels.
Mic sensitivity
With this function, you can select the desired microphone sensitivity between 1 (insensitive) and 10
(sensitive).
Invert PAN
With this function, you can reverse the PAN-movement.
Sub menu
DMX/Sound/
Auto 1/Auto 2
001~ 512
13 CH
1 – 10
ON/OFF
ON/OFF
Black/OFF
Keep/clear
Mode 1/Mode 2
OK/Cancel
PAN = XXX ...
26/32
Function
DMX mode/music control/auto program 1+2
DMX address setting
Number of DMX channels
Microphone sensitivity
Reverse movement
Display turn off
Action if no DMX
Dimmer speed (step response)
Restore factory settings
Test function
Software version
Error message
Fixture running time
Running time since last switch-on
Only service function for producer
Display reverse 180 degree
Display language select - English/Chinese
00137074, Version 1.0