Fence Assembly - Grizzly G0510 Instruction Manual

4. Place the shaper table upside down on two
sturdy blocks that are at least 3
ground as shown in Figure 7. Make sure the
spindle DOES NOT touch the ground or the
weight of the shaper may damage the spin-
dle.
5. Place the stand assembly on the shaper and
attach it with the M8 carriage bolts,
ers, and M8 hex nuts as shown in Figure 7.
Figure 7. Attaching stand to shaper unit.
6. Have an assistant help you turn the shaper
unit rightside-up.
7. Level the shaper with a carpenter's level,
then tighten all of the assembly bolts on the
stand.
NOTE: Sheet steel will often "spring" after it has
been fabricated at the factory, occasionally mak-
ing it difficult to line up precisely with other parts
without a bit of effort. Do not be surprised if the
stand requires a bit of "persuasion" to fit together.
On the other hand, if the parts just do not seem to
work together, try switching parts around (such as
crossbars). If that does not work, call our service
department and we will help you remedy the situ-
ation.
G0510 3⁄4 HP Shaper
1 ⁄ " off the
2
The Model G0510 Shaper comes with a two-piece
adjustable fence. The wood fence pieces included
with the Model G0510 are pre-drilled and coun-
terbored to allow the slotted mounting screws to
3 ⁄ " wash-
rest below the wood surface once they are tight-
8
ened. Note—Most woodworkers like to replace
the wood pieces on the fence with wider and
thicker boards. This gives the user greater stabil-
ity and a larger bearing surface.
The following procedure will ensure that the
fence is parallel with itself and square with the
table:
1.
2.
3.
If you resurface your fence faces, make
sure the fence mounting bolt holes are
countersunk deep enough so the jointer
knives will not come in contact with the
heads of the bolts!
4.

Fence Assembly

Ensure that the bolts on each side are tight
and adequately countersunk.
To align the wood fences, adjust one or both
fence halves so they are in close alignment.
Micro-adjust and check the alignment with a
good straightedge.
If the boards are not coplanar with each
other, resurface the wooden fences as one
unit. You can perform this operation on a join-
ter.
NOTICE
Once you are satisfied that the fence is co-
planar, mount the fence assembly on the
shaper table. The mounting studs are already
attached to the table. All you will need to do
is remove the nuts, place the fence assembly
on the studs and retighten the nuts.
-13-