Stand Assembly - Grizzly G0510 Instruction Manual

!
Disconnect power from
the machine when per-
forming
nance,
adjustments. Failure to
do this may result in seri-
ous personal injury.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Some metal parts may
have sharp edges on
them
formed. Please examine
the edges of all metal
parts before handling
them. Failure to do so
could result in injury.

Stand Assembly

The Model G0510 Shaper features an A-frame
stand.
To assemble the stand:
1. Lay one stand side on the ground and attach
the cross bars with the M8 carriage bolts,
washers, and M8 hex nuts as shown in
Figure 4. DO NOT fully tighten the nuts and
bolts at this time.
2. Attach the second stand side to the assem-
bly. Note—At this point, the assembly will be
somewhat wobbly. Have an assistant hold
the assembly in place while you attach the
nuts and bolts.
-12-
any mainte-
assembly or
after they are
3
⁄ "
8
Figure 4. Attaching cross bars to stand side.
3. Attach the 4 rubber feet to the bottom of the
side panels with the M6-1.0x12 hex bolts,
M6-1.0 hex nuts and
ed. See Figures 5 and 6.
Figure 5. Rubber foot assembly order.
Figure 6. Attaching rubber feet to stand
assembly.
3
/ " flat washers provid-
8
G0510 3⁄4 HP Shaper