Table of Contents
Advertisement
Figure 6.6 (Generic Fireplace Shown) To attach the first
section of vent pipe, make sure to use the fiberglass gasket
in the manual bag to seal between the first vent component
and the outer fireplace wrap. Use 2 self tapping screws to
secure the gasket to the outer wrap.
Secure the first section of venting to the fireplace by screw-
ing through the two straps left over from cutting the seal
cap strap in step 2.
Rear Vent
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
WARNING! Risk of Fire! DO NOT remove the installed
piece of insulation from the firebox top on 8000C-IFT
models. Overheating will occur.
Figure 6.7 (Generic Fireplace Shown) Fold the tabs
toward the center of the seal cap (90º) and remove the
insulation gasket.
Figure 6.8 (Generic Fireplace Shown) Cut the metal
retaining band and fold the sides out.
40
Heat & Glo • 6000C-IFT, 8000C-IFT Installation Manual • 2502-980 Rev. M • 3/21
Figure 6.9 (Generic Fireplace Shown) Fold the center
parts of the retaining band out and use to remove the seal
cap.
NOTICE: Once the seal cap has been removed it CANNOT
be reattached.
Figure 6.10 (Generic Fireplace Shown) Discard the vent
cap, remove and discard the insulation basket.
Advertisement
Table of Contents
