Using The Features - Greenlee CMI-200 Instruction Manual

Using the Features

• DCA Zero To zero the DCA residual value, press and hold DCA Zero until LCD reading
shows zero. When using this feature, unit stays in autoranging mode.
• REL Finds the difference between two measurements. While taking a measurement,
press to set the display to zero. The
measurement. The value on the display will be the difference between the two measure-
ments. Press and hold REL to exit this mode.
• MAX/MIN (PEAK) Holds the minimum or maximum value on the display. Since this feature
only operates with manual ranging, press the
appropriate range, as described below. Press once to hold the minimum value; press again
to hold the maximum value (or peak value, if measuring AC signal). Press again to exit this
mode.
• RANGE Press once to enter the manual ranging mode. The
from the display. Press repeatedly to step through the ranges. Press and hold to return to
the automatic ranging mode.
Note: When using MAX/MIN or
mode.
• HOLD Press momentarily to hold the present value on the display. Press again to exit
this mode.
• Automatic Power Off To extend battery life, the meter will shut itself off after approximately
30 minutes of inactivity. To restore power, press HOLD.
• Current Analog Output This feature allows the current waveform to be viewed on an
oscilloscope. It also allows the current to be recorded by a data logger.
icon will appear on the display. Take the second
RANGE button first to select the
mode, pressing RANGE will cause the meter to exit that
CMI-200
icon will disappear
9