Indoor Evaporator Selection; Electric Heater Selection - Carrier Infinity SYSTXCCITC-01SI Installation Instructions Manual

System control

Table of Contents

5.3.

Indoor Evaporator Selection

If a furnace is installed with a variable capacity heat pump or an 18VS heat pump or

19VS air conditioner, a screen will appear to select the installed indoor evaporator

coil. This selection is used to adequately calculate the refrigerant charge required

while in the heat pump charging screens under Refrigerant Charging, Section 6.6.

Select "other" for non- - Carrier evaporators.

5.4.

If the indoor equipment is a fan coil, the control will display "Searching for heater"

until one is found. If the electric heater is not self- - identifying, the select heater

screen will appear. Touch the appropriate heater size; then, touch SELECT.

A13118

A13119

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the Infinity SYSTXCCITC-01SI and is the answer not in the manual?

Infinity systxccitc01-b