Revolabs 10-FLX2-020-VOIP System Manual page 71

RF Setting
Use the RF Setting page to set the Radio Frequency (RF) signal strength of the base
station and microphones. There are two RF Power settings: High or Low. The default is
High. Low can be selected to reduce the signal strength. Lower signal strength reduces
the maximum distance between the base station and any of the wireless devices. A
lower setting might be desirable in environments where more wireless DECT traffic is
encountered.
The illustration below shows the RF Setting page. It is not necessary to restart the
phone after changing the RF Power setting, but it is necessary to press "Save" for the
change to be taken into the phone.
Access Control
Use the Access Control page to set the system password, enable or disable the Recent
Call list on the FLX Handset, and enable or disable web access. The illustration below
shows the Access Control page. You do not need to restart the phone for changes to
take effect, but will need to press "Save" for the change to be taken into the phone.
Access Control
Password The password is used to control access to the web interface and the
advanced Administrator settings on the FLX Handset. The password
must be four digits. The default password is 7386. This password
should be changed by the system administrator. Please ensure that
you take note of the changed password.
Recent Call Use the Recent Call Enabled option to enable or disable the Recent
Enabled Calls list on the FLX Handset. The default setting is On.
Web Access Use the Web Access Enabled option to enable or disable the FLX
71