Table of Contents
Advertisement
Enabling Web Access
To enable the web interface, from the FLX Handset select Menu > Setup > Advanced
Setup, enter the administrator password, then select Admin Settings > Web Access
ON/OFF. Press the Enter button to toggle between ON and OFF to control access.
Factory default is web access enabled. To change the password needed to access both
the web interface and advanced settings on the Handset, see the Set Password section
on page 46. The web interface also includes a web session timeout to protect against
unwanted access if the session is left open for more than fifteen minutes.
Connecting to the FLX Web Interface
To use the web interface, open a web browser and navigate to the IP address of the
FLX. If you do not know the IP address of your FLX system, on the handset open the
menu, System Info, About System. The IP address is listed here. The Login page will
appear as shown below.
Enter the administrator password and click Login.
After logging in, the FLX Home page will appear. The FLX web interface is organized
into three categories: Home, User and Administrator. Choose any one of these
categories by clicking on the corresponding link in the upper right corner.
52
Advertisement
Table of Contents
