Fuser Fan - Brother HL-2230 Service Manual

9.12 Fuser fan

(1) Disconnect the Connector of the Fuser fan from the High voltage power supply PCB
ASSY.
(2) Remove the Harness of the Fuser fan from the Guides of the Main frame R ASSY.
(3) Release the Hooks to remove the Fuser fan.
High voltage power supply PCB ASSY
Hook
Label
Assembling Note:
• When assembling the Fuser fan, attach the Fuser fan after inserting the Harness into
the Guides of the Main frame R ASSY.
• When assembling the Fuser fan, place it so that the attached label faces outwards.
• When assembling the Fuser fan, secure the harness to the position of figure above with
the Tape.
Hook
Fuser fan
Fig. 3-39
3-41
Connector
Guides
Tape
Main frame R ASSY
Confidential