Paper Exit Unit; Rear Cover (U); Top Cover (Paper Exit Cover) / Fuser Fan (Fufan) - Brother HL-2400C Service Manual

4.4

Paper Exit Unit

4.4.1

Rear Cover (U)

1) Remove the rear cover (R). (Refer to Section 4.3.6 in this chapter.)
2) Remove the set screw BT4X6 (1 pc.) of rear cover (U).
3) Remove the rear cover (U).
Rear Cover (U)
Rear Cover (R)
4.4.2

Top Cover (Paper Exit Cover) / Fuser Fan (FUFAN)

1) Remove the set screws BT4X8 (2 pcs.) that act as the paper exit unit hinges.
2) Remove the set screw ST3X6 (1 pc.) of the inner cover (R) and remove the inner
cover (R).
3) Disconnect the 3 cable joint connectors in the cover assembly.
4) Remove the paper exit unit from the printer.
5) Remove the arm edge cover.
Arm edge cover
Inner cover (R)
Fig.7-54
Fig.7-55
VII-33

Paper Exit Unit