Multiple Transmitter Selection - ATEN IOGear GWHDMS52 User Manual

Multiple Transmitter Selection

1. Verify that the power is removed from Transmitter 1. Press Transmitter No. key on the
remote control and point it at Receiver 1.
OSD Displays:
Select Transmitter Number:
→ GWHDMS52
→ GWHDMS52
SETUP
Up to 4 transmitters may be detected. Press up / down and OK button on remote
control for selection.
2. Enter SETUP menu. OSD Displays:
SETUP:
→ Add New Transmitter
→ Remove Transmitter
→ Modify Transmitter Name
 Return
3. Enter "Add New Transmitter" menu if you would like to add a Transmitter.
OSD Displays:
SEARCHING......
During this period, press and hold the power down on Transmitter 2, and plug in power.
Hold the power button down until the Power LED on Transmitter 2 start to blink orange
which indicates that the Transmitter 2 has entered the "connecting" mode. After the
receiver has found the new transmitter, the OSD Displays.
Select New Transmitter
→ GWHDMS52
 Return
Press transmitter no. key to escape
SEARCHING
24