HomeMatic HM-ES-PMSw1-Pl-DN-R3 Operating Manual page 7

Start-up
As soon as a device has been taught-in to a Central Control
Unit, it can only be connected to other components via this
unit.
Each device can only be taught-in to one Central Control Unit.
During teach-in, please make sure you maintain a distance of
at least 50 cm between the HomeMatic devices and the
Central Control Unit.
To teach-in your device to the Central Control Unit, proceed as follows:
• Open the "WebUI" user interface in your browser. Click the "Teach-
in devices" button on the right-hand side of the screen.
• To activate teach-in mode, click "Start teach-in mode" in the next
window.
12
• Teach-in mode remains activated for 60 seconds. An information
box shows how much teach-in time remains.
• Meanwhile, activate the teach-in mode of the switch actuator to
teach-in as well. Therefore, press and hold the channel button (A)
for at least 4 seconds. The device LED (B) will slowly flash orange
to indicate that teach-in mode is active.
• After a short time, the newly taught-in device will appear in the in-
box of your software interface. The button „Inbox (x new devices)"
indicates how many new devices have been taught-in successfully.
Start-up
> 4 s
13