Table of Contents
Advertisement
022
DMX Control Mode
Operating in a DMX Control mode environment gives the user the greatest flexibility, when it comes
to customizing or creating a show. In this mode, you will be able to control each individual trait of the
fixture and each fixture independently.
Daisy Chain Connection
1.
Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first
fixture.
2.
Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to the
input connector of the next fixture consisting of a (male) 3 pin connector. Then, proceed to connect from
the output, as stated above, to the input of the following fixture and so on.
Universal DMX Controller
3 Pin XLR DMX cable
DMX mode setup
1. Press the Mode button, until the display reads [
2. Press the Up/Down buttons until the display reads [
3. Set the DMX address value by using the Up/Down buttons. Press Enter.
4. Press the Mode button.
COLORstrip™ Mini User Manual
Color fade
You can use the
Master/Slave link to
control multiple units as
one DMX device. Read the
instructions on the
following page.
13
F
= Green
C
= Blue
P
= Run speed
DMX Input
DMX Output
Continue...
SYS
]; then, press Enter.
S dAd
]; then press Enter.
1/26/2010 2:49 PM
Advertisement
Table of Contents
