Master/Slave & Stand Alone; Built In Programs Detailed - Chauvet Indoor Furnishings User Manual

SYS
S Aad
Master/Slave & Stand Alone
MASTER UNIT Settings
Press the Mode button. Then, by using the
Up/Down buttons, select [ ] and press the Enter
button.
Select programs by using the Up/Down
buttons. Press the Enter button.
Some programs have additional controls such as flash
and run speed. Press the Mode button to toggle
additional functions, then use the Up/Down
buttons to change values.
Refer to the Control Panel Modes & Functions
chart on the previous page.
SLAVE UNIT Settings
Units that follow the Master unit
will automatically synchronize to
the Master unit. No other
settings are required.
Turn ON the Master unit last! This will assure that the Master unit will fully detect all linked units, and re-configure its

Built in programs detailed

COLORstrip™ Mini User Manual
Re-establishes correct number of down-link fixtures for sequential chase runs.
The Master/Slave mode will allow you to link units in a daisy chain fashion. In this mode, the first unit
in the daisy chain will command all other units following. Stand Alone can simply be achieved by
setting all units to Master. They would no longer be required to be linked in series.
3 Pin XLR DMX cable
IMPORTANT INSTRUCTIONS FOR MASTER/SLAVE OPERATION
built-in sequential chase programs to run on the correct number of linked units.
P F
ROGRAM UNCTION
000
Blackout
001-007
Solid flashing colors
008-013
Color chase programs
014-020
Sequential color chase patterns
021
RGB (manual color mix)
Re-initialize fixture
Master
Slave
Slave
Slave
O
PTIONS
F
= Flash speed
P
= Run speed
F
= Flash speed
Use sound sensitivity rotary knob to adjust sound
level for optimum response or decrease sensitivity
completely to operate in Run speed only
P
= Run speed
P
= Red
12
Master/Slave Link
output
DMX signal output
does not continue
on M/S linked
fixtures.
1/26/2010 2:49 PM