Projecting; Selecting The Input Signal - Panasonic PT-RW620 Operating Instructions Manual

Projecting

Check the external device connection (x page 48) and the power cord connection (x page 55), and turn on
the power (x page 56) to start projection. Select the image to project, and adjust appearance of the projected
image.

Selecting the input signal

The input of the image to project can be switched.
The input for projection can be switched by directly specifying it with the input selection button on the remote
control or the control panel.
1) Press the input selection button (<RGB1/2> or <RGB1> and <RGB2>, <DIGITAL LINK>, <DVI‑D>,
<VIDEO>, <SDI>, <HDMI>) on the remote control or the control panel.
<RGB1/2>
<RGB1>
<VIDEO>
<RGB2>
<DIGITAL LINK>
<DVI-D>
<SDI>
*1
<HDMI>
*1 SDI input is supported only for PT-RZ770, PT-RZ660.
Attention
f Images may not be projected properly depending on the external device, or the Blu-ray disc or DVD disc, to be played back.
Set the [PICTURE] menu → [SYSTEM SELECTOR].
f Confirm the aspect ratio of the projection screen and the image, and switch to an optimum aspect ratio from the [POSITION] menu →
[ASPECT].
Note
f When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the <DIGITAL LINK/
LAN> terminal, the input on the DIGITAL LINK output supported device changes each time the <DIGITAL LINK> button is pressed. The input
can also be changed using the RS-232C control command.
For twisted-pair-cable transmitters of other manufacturers, switch the input on the projector to DIGITAL LINK, and then switch the input on
the twisted-pair-cable transmitter.
f Set the [DISPLAY OPTION] menu → [RGB IN] → [RGB1 INPUT SETTING] in accordance with the signal input to the <RGB 1 IN> terminal.
66 - ENGLISH
Chapter 3 Basic Operations — Projecting
Remote control
Switches the input to RGB1 or RGB2.
Switches to the other input when one input has already been selected. The image of the signal input
to the <RGB 1 IN> terminal or the <RGB 2 IN> terminal is projected. Input selection can be fixed to
RGB1 or RGB2 using the [SECURITY] menu → [CONTROL DEVICE SETUP].
Switches the input to RGB1.
The image of the signal input to the <RGB 1 IN> terminal (<R/P
HD>, <VD>) is projected.
Switches the input to RGB2.
The image of the signal input to the <RGB 2 IN> terminal is projected.
Switches the input to DIGITAL LINK.
The image of the signal input to the <DIGITAL LINK/LAN> terminal is projected.
Switches the input to DVI-D.
The image of the signal input to the <DVI-D IN> terminal is projected.
Switches the input to SDI.
The image of the signal input to the <SDI IN> terminal is projected.
Switches the input to HDMI.
The image of the signal input to the <HDMI IN> terminal is projected.
Control panel
/VIDEO>, <G/Y>, <B/P
R
/C>, <SYNC/
B