[Sdi In] - Panasonic PT-RW620 Operating Instructions Manual

5) Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT]
[SCREEN FIT]
[USER]
f Proceed to Step 10) when [DEFAULT] or [SCREEN FIT] is selected.
6) Press the <ENTER> button.
f The [RESOLUTION] screen is displayed.
7) Press asqw to select [RESOLUTION].
f Select [1024x768p], [1280x720p], [1280x768p], [1280x800p], [1280x1024p], [1366x768p], [1400x1050p],
[1440x900p], [1600x900p], [1600x1200p], [1680x1050p], [1920x1080p], [1920x1080i], or [1920x1200p].
8) Press the <ENTER> button.
f The [VERTICAL SCAN FREQUENCY] screen is displayed.
9) Press qw to switch [VERTICAL SCAN FREQUENCY].
f Select [60Hz], [50Hz], [30Hz], [25Hz], or [24Hz] when [1920x1080p] is selected for [RESOLUTION].
f Select [60Hz], [50Hz], or [48Hz] when [1920x1080i] is selected for [RESOLUTION].
f Select [60Hz] or [50Hz] when anything other than following is selected for [RESOLUTION].
g [1920x1080p], [1920x1080i]
10) Press the <ENTER> button.
f The confirmation screen is displayed.
11) Press qw to select [OK], and press the <ENTER> button.
Note
f Settings in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] are displayed in the [DIGITAL LINK IN] screen.
f Setting of the resolution and the vertical scanning frequency may be necessary on the computer or video device in use.
f The computer, video device, or projector in use may require the power to be turned off and on again after setting.
f The output with the set resolution or vertical scanning frequency may not be possible depending on the computer or video device in use.

[SDI IN]

(Only for PT-RZ770, PT-RZ660)
Set this item in accordance with the signal input to the <SDI IN> terminal.
Setting [SIGNAL LEVEL]
Select the amplitude of the signal to input.
1) Press as to select [SDI IN].
2) Press the <ENTER> button.
f The [SDI IN] screen is displayed.
3) Press as to select [SIGNAL LEVEL].
4) Press qw to switch the item.
[64-940]
[4-1019]
Setting [BIT DEPTH]
1) Press as to select [SDI IN].
2) Press the <ENTER> button.
f The [SDI IN] screen is displayed.
3) Press as to select [BIT DEPTH].
Chapter 4 Settings — [DISPLAY OPTION] menu
Standard setting.
Changes the EDID data according to the [SCREEN FORMAT] setting.
Sets the [RESOLUTION] and [VERTICAL SCAN FREQUENCY] items as EDID.
Normally use this setting.
Select this item when gray is displayed as black.
ENGLISH - 107