Remote 2 In> Terminal - Panasonic PT-RW620 Operating Instructions Manual

r Lens control command
Command Sub command
VXX LNSI2
VXX LNSI3
VXX LNSI4
VXX LNSI5
<REMOTE 2 IN> terminal
It is possible to control the projector remotely (by contact control) from a control board located away from the
projector where remote control signals cannot reach.
Use the <REMOTE 2 IN> terminal on the connecting terminals of the projector to connect to the control board.
Installation locations in meeting rooms, etc.
Pin assignments and signal names
D-Sub 9-pin
Outside view
(5) (1)
(9) (6)
Attention
f When controlling, make sure to short-circuit pins (1) and (9).
f When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control are disabled. Commands for
RS-232C and network functions corresponding to these functions are also disabled.
g Power on <b> button, power standby <v> button, <SHUTTER> button
f When pins (1) and (9) are short-circuited, and then any pins from (3) to (7) and the pin (1) are short-circuited, the following buttons on the
control panel and the remote control are disabled. Commands for RS-232C and network functions corresponding to these functions are also
disabled.
g Power on <b> button, power standby <v> button, <RGB1> button, <RGB2> button, <RGB1/2> button, <DVI-D> button, <HDMI> button,
<DIGITAL LINK> button, <SDI> button, <SHUTTER> button
(SDI input is supported only for PT-RZ770, PT-RZ660.)
Note
f To change the settings of pins (2) to (8), set the [PROJECTOR SETUP] menu → [REMOTE2 MODE] to [USER]. (x page 135)
Chapter 7 Appendix — Technical information
Details
Lens H shift
+00000 = Fine adjustment 1+, +00001 = Fine adjustment 1-, +00100
Lens V shift
= Fine adjustment 2+, +00101 = Fine adjustment 2-, +00200 = Coarse
Lens focus
adjustment+, +00201 = Coarse adjustment-
Lens zoom
Pin No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Remark
Remote control
Remote control/contact control
Standby
RGB1
RGB2
DVI-D
Remote control board in another location
Signal name Open (H)
GND ―
POWER OFF
RGB1 Other
RGB2 Other
DIGITAL LINK Other
HDMI Other
DVI-D Other
SHUTTER OFF
Controlled by remote
RST/SET
control
Contact control
Lit
Light source
DIGITAL LINK
HDMI
Short (L)
GND
ON
RGB1
RGB2
DIGITAL LINK
HDMI
DVI-D
ON
Controlled by external
contact
ENGLISH - 195