Light Source/Temperature Indicators; When An Indicator Lights Up - Panasonic PT-RW620 Operating Instructions Manual

Chapter 6 Maintenance — Light source/temperature indicators

Light source/temperature indicators

When an indicator lights up

If a problem occurs inside the projector, the light source indicators <LIGHT1>/<LIGHT2> or temperature indicator
<TEMP> will inform you by lighting or blinking. Check the status of the indicators and take following measures.
Attention
f When switching off the projector to deal with problems, make sure to follow the procedure in "Switching off the projector" (x page 65).
Light source indicators <LIGHT1>/<LIGHT2>
Indicator status
Some of the elements of the light
Lighting in red source are defective and the light
output has decreased.
Blinking in red The light source is turned off since the
(1 time) projection lens cannot be detected.
Blinking in red
The light source does not light up,
(2 times)
or the light source turns off while the
Blinking in red
projector is in use.
(3 times)
Note
f If the light source indicators <LIGHT1>/<LIGHT2> are still lit or blinking after taking the measures, set the <MAIN POWER> switch to
<OFF>, and ask your dealer for repairs.
f The light source indicator corresponding to the light source being lit will light up in green if the projector is in projection mode and there is no
indication of problem by lighting or blinking in red.
f The function to detect the projector lens may or may not exist depending on the country or region where you purchased the product.
Light source indicator <LIGHT1>
Light source indicator <LIGHT2>
Status
f Turn the <MAIN POWER> switch to <OFF> (x page 65), and turn on the
power again.
f Turn off the power and mount the projection lens again. (x page 46)
f Turn the <MAIN POWER> switch to <OFF> (x page 65), and turn on the
power again.
f Turn the <MAIN POWER> switch to <OFF> (x page 65), and turn on the
power again.
Temperature indicator <TEMP>
Solution
ENGLISH - 175