Installation and Accessories Unpacking Carefully unpack the M-LYNX-702 monitor and verify that the following items are included: M-LYNX-702 Monitor Power Supply Operating Instructions Control Panel Area Headphone Jack Arrow Keys (up/down and left/right) The Headphone jack on the front panel takes two channels of embedded audio from HDMI or SDI sources.
USB port The USB port is used for service functions. Contact 3G/SDI Input Marshall Electronics for further information. Connect serial digital source here. It is compatible with HDMI Input SDI, HD SDI or 3G SDI sources. Active loop out allows daisy-chaining to other devices.
On Screen Menu Access the main menu by pressing the Menu button on the front panel. Use the Up/Down arrow keys to move within a menu. Use the Right arrow key to access a sub-menu and the left arrow key to move back out of the sub-menu Once in a sub-menu, use the Up/Down arrow keys to select an item to adjust and use the Left/Right keys to change values within their range.
Page 6
Aspect Ratio 16:9 (Display is set to exact 16:9 aspect ratio) 14:9 (Display is set to exact 14:9 aspect ratio) Zoom1 (The picture is expanded) Zoom2 (The picture is expanded twice as much as Zoom1) Panorama (Display is set for wide aspect ratio) Pixel to Pix (Incoming video pixels are mapped 1:1 to display pixels.
Page 7
■ Audio Volume (0 – 100, 50 = default) Balance (-10 - +10, 0 = default) ■ Setting Screen Markers (OFF = Default) Center Marker (OFF = Default) (Places red cross-hairs in middle of screen) Horizontal Position (0 - 10, 5 = default) (Shifts picture left or right) Vertical Position (0 - 10, 5 = default)
Page 8
Component (Component video input is selected as the 2 picture) Upper Left picture appears in the upper-left corner of the screen) Upper Right picture appears in the upper-right corner of the screen) Lower Right picture appears in the lower-right corner of the screen) Lower Left picture appears in the lower-left corner of the screen) PIP Swap...
Monitor Specifications Panel Specifications Electrical Screen Size 2 x 7” Voltage Requirement 12 VDC Screen Resolution 1024 x 600 Brightness 250 cd/m Power Consumption 3.0 A Contrast Ratio 700:1 Viewing Angle 150° (Included power supply meets this requirement) Burn-In Warning Customer-supplied power supply, if used, should be The M-LYNX-702 uses a high quality TFT LCD panel.
Misuse, abnormal handling, alterations or modifications in design or construction void this warranty. It is considered normal for a minimal amount of pixels, not to exceed three, to fail on the periphery of the display active viewing area. Marshall Electronics reserves the option to refuse service for display pixel failure if deemed unobtrusive to effective use of the monitor by our technicians.
Need help?
Do you have a question about the M-LYNX-702W and is the answer not in the manual?
Questions and answers