Wiring - Litex WH44OSB5L Installation Manual

Table of Contents

Advertisement

4. Hanging Bracket Installation.
(cont.)
Install hanging bracket to outlet box using
original screws, spring washers and flat washers
provided with new or original outlet box.* Pull
electrical wiring from outlet box through center
hole in the hanging bracket.
*NOTE: It is very important that you use the
proper hardware when installing the hanging
bracket as this will support the fan.

5. Wiring.

Lift motor assembly to hanging bracket and slide
slot at one end of motor assembly over j-hook on
hanging bracket. This will allow motor assembly to
hang out of the way while wiring.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.
WARNING: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National Electrical
Code. If you are unfamiliar with electrical wiring or if
the house/building wires are different colors than
those referred to below, please use a qualified
electrician.
When fan is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect BLACK and BLUE wire from fan to BLACK
wire from ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire from
ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together from
fan to BARE/GREEN wire from ceiling with wire
connector provided.
If you intend to control the fan light with a
separate light switch, connect BLUE wire from fan
to the BLACK (or RED) supply from the
independent switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
hanging
bracket
spring washers
outlet box screws
outlet box
hanging
bracket
j-hook
motor assembly
page 4
flat washers
(supply circuit)
WHITE
BLACK
SWITCH
GROUND
(GREEN
OR BARE)
BLACK
WHITE
GREEN
WHITE
BLACK
BLUE
wire
connector
GREEN
*

Advertisement

Table of Contents
loading

Table of Contents