Table of Contents
Advertisement
Error Messages (3 of 3)
Error Message
TANK DEVICE LOST (T:01 TO T:24)
Each tekmarNet
on the tank water temperature is no longer reporting back to the 406.
The device can be located by either the address, or by going to each device in the building, checking
that the LCD is on, and the tekmarNet
the lost device looking for loose or damaged wires.
Note: If you deliberately remove a tekmarNet
MASTER DEVICE ERROR
More than one master has been detected on the tekmarNet
Device" and no other tekmarNet
If one has been added, remove it from the system.
DEVICE ERROR AT ADDRESS B:01 to B:24
Each tekmarNet
boiler water temperature has an error. If there is a record of the device address together with the room
name, go to that device to correct the error. Otherwise, go to each device in the building, checking for
the flashing Warning symbol. Once the error on the device is corrected, the error message will clear.
DEVICE ERROR AT ADDRESS M:01 to M:24
Each tekmarNet
mix water temperature has an error. If there is a record of the device address together with the room
name, go to that device to correct the error. Otherwise, go to each device in the building, checking for
the flashing Warning symbol. Once the error on the device is corrected, the error message will clear.
DEVICE ERROR AT ADDRESS T:01 to T:24
Each tekmarNet
tank water temperature has an error. If there is a record of the device address together with the room
name, go to that device to correct the error. Otherwise, go to each device in the building, checking for the
flashing Warning symbol. Once the error on the device is corrected, the error message will clear.
DEVICE ERROR AT ADDRESS T:01 to T:24
Each tekmarNet
tank water temperature has an error. If there is a record of the device address together with the room
name, go to that device to correct the error. Otherwise, go to each device in the building, checking for
the flashing Warning symbol. Once the error on the device is corrected, the error message will clear.
®
device (thermostat, setpoint control, timer) has an address. The device with this address
®
communication symbol is on. Trace the wires from the control to
®
®
reset controls can be added to the tekmarNet
®
device (thermostat, setpoint control, timer) has an address. One of the devices on the
®
device (thermostat, setpoint control, timer) has an address. One of the devices on the
®
device (thermostat, setpoint control, timer) has an address. One of the devices on the
®
device (thermostat, setpoint control, timer) has an address. One of the devices on the
45 of 48
Description
device, hold the Up and Down buttons to clear this error.
®
4 expansion terminals. The 406 is a "Master
®
4 expansion terminals.
© 2011
D 406 - 12/11
Advertisement
Table of Contents
