Advertisement
Once MS-PoE detects the existence of an IEEE 802.3af device, the LED
indicator will stay steady, ON to show it is providing power.
Note:
If the connected device is not fully complying with IEEE 802.3af
standard or in-line power device, the LED indicator of MS-PoE will not be
steady on.
Installing an MS-PoE and a SP-POE, Injector and
Splitter
1.
Connect a standard network cable from "Ethernet+DC" of MS-PoE to
"Ethernet+DC" of SP-POE. The POE LED of MS-PoE / SP-POE will light on
continuance.
2.
Connect the UTP cable in the package from "Ethernet" of SP-POE to the
RJ-45 port of remote device.
3.
Connect proper DC plug from "DC OUT" of SP-POE to remote device.
4.
Power on the remote device and the LED indicator on SP-POE will
remains on.
Figure 3: Connection architecture over MS-PoE / SP-POE
MS-PoE Injector User Manual
firealarmresources.com
Chapter 2: Hardware Installation
9
Advertisement
