Advertisement
Chapter 2: Hardware Installation
Note:
The MS-PoE and SP-POE can be installed in pair. However, the use of
third-party device is allowed if the device complied with IEEE 802.3af
standard.
Installing the MS-PoE
1.
Connect a standard network cable from Switch/workstation to
"Ethernet" port of MS-PoE.
2.
Connect the long cable that will be used to connect to the remote device
to the port "Ethernet + DC".
3.
Connect an AC adapter to "DC 48V" of MS-PoE. The power LED will be
steady on.
NOTE:
This product is intended to be supplied by a UL Listed Direct Plug-In
Power Unit marked "Class 2" or "LPS" and output rated 48 VDC, 3 Amp
minimum.
4.
Connect with IEEE 802.3af devices, due to the capability of IEEE 802.3af
standard, the MS-PoE can directly connect with any IEEE 802.3af end-
nodes like wireless access point, VoIP phones and Internet camera
where support IEEE 802.3af In-line Power over Ethernet port.
Figure 2: Connection to the IEEE 802.3af device
8
firealarmresources.com
MS-PoE Injector User Manual
Advertisement
