Page 1
5106 Azusa Canyon Road Irwindale, CA 91706 Tel. 626-962-7770 Fax. 626 962-7720 he information contained herein is the property of FALCON ® ELECTRIC INC., is proprietary, confidential, and not to be disclosed, disseminated or used except for the purpose provided.
CAUTION This UPS utilizes voltage that may be hazardous. Do not attempt to disassemble. This unit contains no user replaceable parts. Refer all servicing to Falcon Electric, Inc. CAUTION This UPS is not intended to be used in conjunction with life support or operating room equipment.
ED2400RM-1 2400 (1680 Watts) ED2500RM-1 2500 (1750 Watts) The FALCON ® ED Series represents one of the smallest and most compact units of the FALCON ® UNINTERRUPTIBLE POWER SYSTEM (UPS) product line. In the tradition of all FALCON ® products, it maintains the highest reliability and the most complete on-line, sinewave power protection available.
If the unit is overloaded, will shutdown completely if the overload is not corrected within 15 seconds. FIGURE 1: FALCON ED SERIES BLOCK DIAGRAM EMERGENCY BYPASS LINE...
MODEL SELECTION GUIDE U N I T N AM E ED 1500R M - 1 ED 2000R M - 1 ED 2400R M - 1 ED 2500R M - 1 N om i nal VA 1500 2000 2400 2500 C ur r ent - I nput C ur r ent - O ut put R M S 8.
To file a claim for shipping damage or concealed damage: 1) File with the carrier within 15 days of receipt of the equipment; 2) Send a copy of the damage claim within 15 days to the Falcon ® Service Department.
UPS is overloaded or has failed. Should this occur, check the load level and correct any overload condition if present. During this condition, UPS load outlets will be powered by filtered utility bypass power. Should the unit not be overloaded, call FALCON ® support for further assistance.
TYPICAL UPS REAR PANEL LAYOUT DB-9F CONTACT CLOSURE INTERFACE This connector gives access to the UPS contact closure status interface. Please reference page 8 of this manual for details. Inlet for Input Line Cord is permenently attached to ED1500RM-1, ED2000RM-1, ED2400RM-1 and ED2500RM-1. COOLING FANS (2) Cooling fans draw cool air from the outside of the rear panel and exhaust it out through slots in the UPS front panel.
CHAPTER CHAPTER OPERATION The FALCON ® ED unit is very simple to use. Verify the power cord is plugged into the correct voltage power source. Activate the power switch to the "ON" position. The green AC LED illuminates. The green INV LED illuminates.
To escape this condition, the problem must first be corrected. Then turn the UPS power switch "OFF", then back "ON". It is recommended that you leave the ED unit power switch "ON" at all times and switch your devices "OFF" individually. This will insure that your batteries are always at a maximum charged state.
C. Spent batteries must be recycled in accordance with all Federal, State and local laws. To locate a recycling center near you, contact the Falcon service department. CAUTION A.
The following precautions should be observed by a qualified technician when working with batteries. Remove watches, rings, or other metal objects. Use tools with insulated handles. Wear rubber gloves and boots. Do not lay tools or metal parts on top of batteries Storing the UPS and Batteries Should you need to store the UPS for a long period, fully recharge the battery just prior to storage and recharge the battery every 6 months by plugging the...
Technical Support Your FALCON ® Electric ED Series UPS is backed by one of the finest customer service teams assembled. Write, call, fax or email should you require technical assistance or service. FALCON ELECTRIC, INC. 5106 Azusa Canyon Road Irwindale, CA. 91706 Voice 626.962.7770...
Need help?
Do you have a question about the ED Series and is the answer not in the manual?
Questions and answers