Error Messages; Operation Beep - Brother CE1125PRW Operation Manual

Symptom
The thread tension is incorrect.
The stitch is not The thread is tangled, for example, in
sewn correctly.
the race.
The stitch adjustment level is incorrect. Adjust the stitch.

ERROR MESSAGES

If an operation is performed incorrectly before the sewing machine is set up, an error message appears on the
operation panel. Follow the instructions indicated in the table.
If you press the stitch selection key or do the operation correctly while the error message is displayed, the
message disappears.
Error Message
The foot controller was pressed (or the start/
stop button was pressed if the foot controller is
not connected) and the reverse/reinforcement
stitch button was pressed while the presser foot
is raised.
A stitch other than the buttonhole or bar tack
stitch was selected and the foot controller was
pressed (or the start/stop button was pressed if
the foot controller is not connected) while the
buttonhole lever is lowered.
The buttonhole or bar tack stitch was selected
and the foot controller was pressed (or the start/
stop button was pressed if the foot controller
is not connected) while the buttonhole lever is
raised.
The reverse/reinforcement stitch button or
needle position button was pressed while the
bobbin winder shaft is moved to the right.
The start/stop button was pressed while the
foot controller was connected.
The motor locked up because the thread
became tangled, or the needle bent and thus
hit the needle plate.
The machine may be malfunctioning.

Operation beep

Each time a key is pressed you will hear one beep. If a non-functioning key is pressed or an incorrect operation
is performed you will hear two or four beeps (only for models equipped with the operation beep).
■ If a key is pressed (correct operation)
One beep sounds.
■ If an incorrect operation is performed or a non-functioning key is pressed
Two or four beeps sound.
■ If the machine locks up, for example, because the thread is tangled
The sewing machine beeps for four seconds and the machine automatically stops. Be sure to check for the
cause of the error, and correct it before continuing to sew.
Possible cause
Probable Cause
How to put it right
Adjust the tension of the upper thread.
Remove the tangle thread. If the thread
is tangled in the race, clean the race.
Solution
Lower the presser foot lever before continuing
the operation.
Raise the buttonhole lever before continuing
the operation.
Lower the buttonhole lever before continuing
the operation.
Move the bobbin winder shaft to the left before
continuing the operation.
Disconnect the foot controller, and then press
the start/stop button. Otherwise, operate the
machine by using the foot controller.
Clean the race to remove the tangled thread
(page 60).
Check the needle. If the needle is bent or
broken, replace the needle (page 21).
If both of the above fail, refer to "Error message
"E6" appears in the LCD" (page 65).
Contact your nearest authorized service center.
APPENDIX
Reference
page 27, 62
page 60, 62
page 50
4
71