Thread Tension - Brother CE1125PRW Operation Manual

1 Sewing speed controller
7
Start sewing in the following way.
Press down the foot
controler slowly.
X The machine starts sewing.
8
Take your foot off the foot controller, or press
(start/stop button) once.
X The machine stops sewing.
9
Raise the needle by turning the handwheel
toward you (counterclockwise) so that the mark
on the wheel points up. (Or press
position button) once or twice for models
equipped with the needle position button.)
This procedure is not necessary if the needle
stop position has been set to the raised position
(page 10).
10
Raise the presser foot lever.
1 1
Pull the fabric to the left side of the machine,
and then cut the threads by using the thread
cutter.
1 Thread cutter
Note
• When the foot controller is plugged in, the start/
stop button cannot be used to start sewing (for
models equipped with the start/stop button).
• When sewing is stopped, the needle remains
lowered (in the fabric). The machine can be set
so that the needle will stay up when sewing is
stopped. For details, refer to "Changing the needle
stop position" (page 10).
or
Press (start/stop button)
(for models equipped with
the start/stop button).
(needle
■ Sewing reinforcement stitches
When sewing stitches other than straight or zigzag
stitches that are secured with reverse stitching,
pressing (reverse/reinforcement stitch button)
sews reinforcement stitches, 3 to 5 stitches on top of
each other.
1 Reverse stitching
2 Reinforcement stitching
Memo
• Whether reverse stitches or reinforcement stitches
are sewn depends on the stitch that is selected.
For details, refer to "STITCH SETTINGS" (page
52).

Thread tension

The thread tension will affect the quality of your
stitches. You may need to adjust it when you change
fabric or thread.
Memo
• We recommend that you do a test sewing on
scrap of a fabric before you start to sew.
■ Correct tension
Correct tension is important as too much or too little
tension will weaken your seams or cause puckers on
your fabric.
1
2
3
4
■ Upper tension is too tight
Loops will appear on the surface of the fabric.
Note
• If the bobbin thread was incorrectly threaded, the
upper thread may be too tight. In this case, refer
to "Lower threading" (page 14) and rethread
the bobbin thread.
SEWING BASICS
1 Wrong side
2 Surface
3 Upper thread
4 Lower thread
27
2